Scott Drake Fender Splash Shield
0 results found
No products match your current filters
Try the following
- Remove some filters to broaden your results.
- Clear the vehicle filter to see all available products.
- Check a different category or manufacturer.
- Browse the top categories below to find what you need.
Scott Drake Fender Splash Shields: Factory-Correct Protection for Your Classic Mustang
When restoring a classic Ford Mustang, it is easy to focus on the headline components and overlook the parts quietly doing the hard work behind the scenes. Fender splash shields are a perfect example. Tucked inside the front fender wells, these shields act as the first line of defense against water, mud, and road debris that would otherwise accumulate against bare metal — accelerating corrosion and shortening the life of a painstakingly restored body. For a vehicle you have invested years into, that protection matters.
Scott Drake has built its entire reputation on getting the details right for classic Mustang restorations. As the world's largest manufacturer and supplier of reproduction parts for classic Mustangs, Scott Drake approaches even supporting components like splash shields with the same OEM-level precision it brings to more visible exterior pieces. The result is a splash shield lineup that fits and installs the way it did from the factory floor — because for serious restorers, "close enough" is never the standard.
What Makes Scott Drake Splash Shields Stand Out
Scott Drake's fender splash shields are engineered in two-piece ABS plastic construction, with outer rubber strips pre-stapled to each shield for an improved seal against moisture intrusion. Each set includes both front and rear shields — typically four pieces total — covering both sides of the vehicle and protecting the entire inner fender cavity from the cowl area forward. This attention to completeness means restorers can address the full fender well in a single purchase rather than sourcing individual pieces.
Coverage spans the most sought-after classic Mustang model years, including the 1964½, 1965, 1966, 1967, 1968, 1969, and 1970 Ford Mustang. Scott Drake also offers a dedicated Splash Shield Mounting Kit — a 16-piece set of zinc-plated screws specifically sized for mounting splash shields beneath the front fenders — so you have the correct hardware to go alongside the shields themselves. Splash shield kits are also available that include rubber seals and mounting hardware, designed to work with either your original shield plates or Scott Drake's new standard shield plates.
This system-level thinking — shields, seals, hardware, all from one trusted source — reflects the broader philosophy that has made Scott Drake a go-to name in the classic Ford restoration community for over three decades. Every part is designed to look, fit, and function exactly as the original, right down to the details that other reproduction manufacturers tend to overlook.
Why Fender Splash Shields Matter for Your Restoration
Splash shields may be invisible once the fenders are on, but their absence is very much felt over time. Without proper shields in place, road spray and debris pack into the fender cavity, holding moisture against inner fender metal and promoting the kind of slow-creeping rust that can quietly undo years of restoration work. Replacing worn, cracked, or missing shields during a restoration or refresh is one of the most cost-effective ways to protect the structural integrity of the front end for years to come.
Browse the full selection of Scott Drake fender splash shields to find the correct set for your Mustang's model year, or explore the complete fender splash shield category for additional fitment options across other makes and models.