H&R 505655711 TRAK+ Wheel Adapters Hubcentric 5/114.3 60.1CB Toyota (Pair)

The H&R 505655711 TRAK+ Wheel Adapters allow you to fit wheels with a different bolt pattern to your Toyota vehicle. Designed for Toyota hubs with a 5/114.3 bolt pattern and 60.1mm center bore, these hubcentric adapters are sold as a pair and are available in thicknesses ranging from 20mm to 25mm.

Like H&R's TRAK+ DRM Series Wheel Spacers, these adapters mount flush to the vehicle hub just as a standard TRAK+ spacer would. The wheel side of the adapter features a different bolt pattern, enabling fitment of non-standard or aftermarket wheels that would not otherwise be compatible with your hub.

In addition to enabling bolt pattern changes, TRAK+ Wheel Adapters push the wheel outward from the hub, widening the vehicle's track. This improves lateral stability, lowers the roll center, and delivers a more aggressive stance with better wheel-well fill.

Key Features:

• Hubcentric design — seats precisely on the vehicle hub for a vibration-free fit
• Adapts 5/114.3 Toyota bolt pattern with 60.1mm center bore
• Sold as a pair (two adapters included)
• Available in 20mm–25mm thickness for track widening
• Proprietary aluminum/magnesium alloy construction — up to 70% lighter than comparable steel
• Hard anodized finish for lasting corrosion and wear resistance
• Suitable for winter use with snow tires and wheels

Wheel Bolt Safety Guidelines:

When using wheel adapters, replacement wheel bolts must be longer than the originals by at least the thickness of the adapter. The bolt head style must match the existing bolts exactly. Refer to the following minimum engagement requirements:

• M12 × 1.25 — 8.0 turns (approx. 10mm load-bearing shaft length)
• M12 × 1.50 — 6.5 turns (approx. 10mm load-bearing shaft length)
• M12 × 1.75 — 6.5 turns (approx. 12mm load-bearing shaft length)
• M14 × 1.25 — 9.0 turns (approx. 12mm load-bearing shaft length)
• M14 × 1.50 — 7.5 turns (approx. 12mm load-bearing shaft length)
• 1/2" UNF — 8.0 turns (approx. 11mm load-bearing shaft length)

After installation, rotate the wheel by hand to confirm free movement and verify that wheel bolts do not contact ABS sensors or any brake system components. Note that clearance tolerance on some vehicles can be as little as 2mm.