H&R 1007957251 TRAK+ Wheel Adapters for Porsche Cayenne 5/130 71.6CB (Pair)

The H&R TRAK+ Wheel Adapters (Part #1007957251) are a pair of hubcentric wheel adapters designed to adapt Porsche Cayenne wheels (5/130 bolt pattern, 71.6mm center bore) to a vehicle with a different bolt pattern. Available in thicknesses ranging from 20mm to 25mm, these adapters mount to the vehicle hub exactly like a standard TRAK+ wheel spacer, but feature a different bolt pattern on the wheel-facing side — allowing fitment of non-standard bolt pattern wheels.

Constructed from a proprietary aluminum/magnesium alloy, H&R TRAK+ adapters weigh up to 70% less than a comparable steel product. Each adapter is hard anodized for a tough, corrosion-resistant finish built to last in all conditions, including winter use with snow tires and wheels.

Key Features:

• Hubcentric design — seats precisely on the vehicle hub for proper centering and vibration-free operation
• Maximizes vehicle track width for improved appearance, lowered roll center, and increased lateral stability
• Made from a lightweight proprietary aluminum/magnesium alloy — up to 70% lighter than comparable steel spacers
• Hard anodized finish for long-lasting durability and corrosion resistance
• Suitable for year-round use including winter applications with snow tires and wheels
• Sold as a pair (two adapters included)

TRAK+ Series Overview:

• DR Series (10–40mm track widening) — Fits between wheel and hub; requires longer wheel bolts (ordered separately). Verify bolt type (taper or round head) and shaft length before ordering.
• DRS Series (10–40mm track widening) — Fits between wheel and hub; requires replacing existing wheel studs with longer ones (longer studs included).
• DRA Series (40–60mm track widening) — Bolts to hub with special wheel bolts (included); provides new threaded holes for wheel bolts.
• DRM Series (40–90mm track widening) — Bolts to hub using existing wheel studs with special nuts (included); wheel bolts to new DRM wheel studs.

Wheel Bolt Selection Guidelines:

• New bolts must be longer than the originals by the width of the adapter used
• Bolt head style must match the existing bolts:

• Taper 60° — End digit 01
• Round head for M12/d24mm or M14/d28mm — End digit 02
• Round head for M12/d26mm (e.g., OE VAG wheels) — End digit 03
• Flat head for Porsche OEM wheels M14×1.5 — End digit 06

Minimum Thread Engagement (Safety Guidelines):

• M12×1.25 — 8.0 turns (~10mm load-bearing shaft length)
• M12×1.50 — 6.5 turns (~10mm load-bearing shaft length)
• M12×1.75 — 6.5 turns (~12mm load-bearing shaft length)
• M14×1.25 — 9.0 turns (~12mm load-bearing shaft length)
• M14×1.50 — 7.5 turns (~12mm load-bearing shaft length)
• 1/2" UNF — 8.0 turns (~11mm load-bearing shaft length)

After installation, always verify that wheel bolts do not contact any brake system components (including ABS sensors). Rotate the wheel by hand to confirm free movement and confirm adequate clearance on the inside of the hub. Note: Maximum tolerance on some vehicles (e.g., Mercedes rear axle) may be as little as 2mm.