UMI Performance 3610 Rear Control Arm Relocation Brackets

UMI Performance 3610 rear control arm relocation brackets are designed to improve traction and eliminate wheel hop by correcting lower control arm geometry. These weld-in brackets lower the rear mounting point of your control arms, creating a lift bar setup that plants the rear tires harder into the ground for better traction and reduced tire spin.

Key Features:

• Two mounting positions: 2-inch or 3-inch drop settings for custom tuning
• Works with factory and aftermarket lower control arms without requiring longer arms
• Corrects suspension geometry on lowered vehicles to prevent traction loss
• Increases rear tire bite on factory-height vehicles by optimizing control arm angle
• Weld-in installation with all necessary hardware and instructions included
• Bare metal finish for welding, approximately 1-2 hour installation time

Application Notes:

• For lowered vehicles: Essential for correcting lost suspension geometry caused by lowering, which raises the rear control arm mount higher than the front
• For factory-height vehicles: Improves instant center point and traction by decreasing control arm angle
• Sway bar compatibility: Will not fit with factory-style rear sway bar unless used with UMI lower control arms (models 3611, 3612, 3613, or 3614)

These relocation brackets are ideal for drag racing, autocross, and street performance applications where maximizing rear traction is critical. The adjustable mounting positions allow you to fine-tune your suspension geometry based on your vehicle's ride height and intended use.