Jones Racing Products Engine Cooling Fan Blade Bolt
Jones Racing Products Fan Blade Bolt Hardware
A cooling fan blade spinning at high RPM is only as secure as the fasteners holding it to the hub. Jones Racing Products approaches this detail the way it approaches the rest of its catalog: with a racing mindset. The company, based in Ottsville, Pennsylvania, is known for billet aluminum belt drive systems and related components, and its modular Hustler fan line relies on dedicated bolt kits to keep each blade firmly mounted to its hub.
Built for the Hustler Modular Fan System
The Hustler fan is a lightweight, low-drag design that pairs a billet 6061-T6 aluminum hub with replaceable bolt-on blades molded from Zytel fiber-reinforced nylon resin. Rather than welding or riveting blades in place, Jones uses small aircraft-quality bolts, with each blade held by three fasteners. That approach lets racers swap a single damaged blade or even the hub without scrapping the entire fan, and it allows the overall diameter to be changed with the same hub.
The Jones Racing Products Hustler fan blade bolt kit supplies the bolts, washers and nuts needed to mount blades on a Hustler fan. Kits are offered for attaching either a single blade or a full set of three, so you can service one blade after a track incident or refresh the hardware on an entire fan during an off-season teardown.
Why Fan Blade Hardware Deserves Attention
Fan hardware lives in a harsh environment of heat, vibration and rotational load. The Hustler design is rated for up to 9,000 RPM, and the hardware is specified as aerospace grade, reflecting how much stress the joint between blade and hub sees. Reusing fatigued or mismatched fasteners is a risk, and installing a fresh, correctly matched kit whenever a blade is replaced is cheap insurance against a blade letting go behind the radiator.
The light rotating mass of the Hustler fan also helps reduce belt wear caused by fan inertia, which is a particular benefit on high-horsepower engines. Keeping the hardware matched to the fan preserves that balance and low-drag character.
What to Check When Choosing a Kit
- Blade count: choose the one-blade kit for spot replacement or the three-blade kit for a complete blade set.
- Fan compatibility: these kits are intended for Jones Hustler 3-blade fans, including the replaceable-blade versions in common diameters.
- Hub condition: inspect the hub's mounting holes whenever blades come off, and replace the hub if damaged, since the system is designed to make that possible.
- Service interval: refresh hardware after any impact, overheating event or blade replacement.
Explore More
Jones Racing Products is a family-owned manufacturer that machines its billet aluminum products in the USA, giving it close control over fit and finish. To compare other fastener options for cooling fans from a range of manufacturers, browse the full Engine Cooling Fan Blade Bolt category, or visit the Jones Racing Products brand page to see the rest of the company's belt drive, pump and cooling lineup.