Ksport CMT220-AR Asphalt Rally Spec AR Coilover Kit Damping Monotube - 36-Way

The Ksport Rally Spec AR Coilover System (CMT220-AR) is an competition-grade suspension solution engineered specifically for asphalt rally racing. Built with extended-stroke dampers and heavy-duty internals, this system is purpose-built to handle the rigors of competitive rally events on paved surfaces while delivering precise, repeatable handling performance.

Damping & Adjustment:

• 36 levels of damping adjustment allow fine-tuned control over ride quality and handling balance
• Simultaneous compression and rebound adjustment via a single knob for quick, easy setup changes
• Application-specific spring rates and shock valving are matched at the factory for optimized performance out of the box

Construction & Materials:

• Mounts and major structural components machined from 6061 billet aluminum for a lightweight, corrosion-resistant build
• Steel shock bodies are zinc electroplated for added protection against rust and the elements
• Large-diameter pistons provide increased oil capacity for improved heat dissipation under sustained competition use

Monotube Design:

• True monotube shock construction separates oil and gas within a single cylinder for superior thermal performance versus twin-tube designs
• Superior heat dissipation and finer damping resolution compared to conventional twin-tube units
• Significantly reduced risk of aeration and cavitation for consistent, fade-free damping during competition

Top Mounts & Height Adjustment:

• Pillow ball top mounts (front and rear, on applicable fitments) preserve OEM suspension geometry while delivering a more direct, communicative steering feel
• Integrated camber adjustability on applicable pillow ball top mounts eliminates the need for a separate camber kit
• Adjustable lower mount design allows ride height changes without sacrificing suspension travel
• Depending on application, vehicle height can be set from OEM level to up to 3 inches below stock

Note: Height range varies by application. Rally sanctioning bodies may have rules governing minimum ride height — verify compliance with your series regulations before installation. Not compatible with OEM electronic damping control systems (EDC, DDS, etc.) unless explicitly stated.