FCS 1334597R Complete Strut Assembly OE Replacement

The FCS 1334597R Complete Strut Assembly is a fully loaded, ready-to-install suspension unit engineered to restore a vehicle's original ride quality, handling, and control. Designed as a direct OE replacement, this assembly ships pre-built with all necessary components, eliminating the need for a spring compressor and significantly reducing installation time compared to traditional bare strut replacement.

Built to meet and exceed original equipment quality standards, the FCS 1334597R features precisely calibrated valving tuned specifically for its application to replicate factory ride and feel. Nitrogen gas charging minimizes fluid aeration and strut fade, helping maintain consistent tire-to-road contact for predictable, stable handling.

Key Features:

• Fully assembled, complete strut — no spring compressor required
• Gas-charged MacPherson strut design with nitrogen gas for reduced fade
• Hard-chrome, mirror-finished piston rod with Freudenberg NOK seals for long service life
• Premium Eneos oil provides consistent damping across a wide temperature range
• Coil spring electrostatically coated for superior corrosion resistance, matched to OE spring rate
• Upper bearing plate tested under extreme load for lasting, rattle-free performance
• Urethane rubber boot kit and bump stop absorb road impact and reduce cabin noise
• Reinforced mounting brackets for structural integrity and durability
• Upper and lower spring isolators keep the coil spring stable under all road conditions
• Application-specific valving calibrated to replicate OE handling characteristics

The FCS 1334597R is backed by FCS Automotive International's limited lifetime warranty to the original purchaser for as long as the part remains installed on the original vehicle. It is recommended to replace struts in pairs — driver and passenger side simultaneously — for balanced suspension performance.