VBOX Motorsports RLCAB019L 5-Pin Lemo to 9-Way D-Sub CAN Interface Cable 1m

The VBOX Motorsports RLCAB019L is a purpose-built CAN bus interface cable designed to connect VBOX data loggers and modules to devices equipped with a 9-way D-sub (DE-9) CAN connector. The cable features a 5-pin Lemo plug on one end and a 9-way D-sub socket on the other, with a 1-meter cable length suited for clean, close-proximity installations in a race car cockpit or test vehicle.

Key Features:

• 5-way Lemo plug (PS-type) on the VBOX side for secure, tool-free locking connection
• 9-way D-sub (DE-9) socket on the device side for compatibility with standard CAN port connectors
• Carries CAN High (CANH) and CAN Low (CANL) signal lines for full CAN bus communication
• 1-meter (approximately 3.3 ft) cable length for tidy, close-range routing
• Compatible with VBOX CAN bus interface modules including the RLVBCAN02 Vehicle CAN Bus Interface
• Wiring follows Racelogic's standard pin-out: CAN H on blue wire, CAN L on white wire
• Part of the RLCAB019L cable family — also available in 2m, 3m, 5m, 10m, and 15m variants

This cable is an essential accessory for integrating VBOX data loggers with third-party equipment or vehicle CAN bus interfaces that use a 9-way D-sub connector. It is also referenced in Racelogic ADAS testing configurations where a 9-way D-sub interface is required for CAN signal routing. Compatible with the RLVBCAN02 and other Racelogic VBOX modules that feature the 9-way D CAN input port.