Zone Offroad J23F 4.5" Suspension Lift Kit Jeep Cherokee XJ Chrysler 8.25 Fox 2.0 Adventure Shocks

The Zone Offroad J23F is a complete 4.5-inch suspension lift kit engineered specifically for the 1984–2001 Jeep Cherokee (XJ) equipped with the Chrysler 8.25 rear axle. This enthusiast-built kit delivers the ground clearance and wheel travel needed to run up to 32-inch tires, transforming your XJ's off-road capability without sacrificing everyday drivability.

Up front, replacement front coil springs are designed for extreme suspension travel and off-road abuse while maintaining a comfortable street ride. High-strength lower control arms fabricated from 1-3/4" x 1/4" thick-wall DOM tubing with greasable urethane ends and dual fluting correct caster and improve axle location. Front bump stop extensions increase wheel travel, and extended sway bar links with urethane bushings maintain proper operating angles to reduce body roll. Brake line relocation brackets are included to allow reuse of factory brake lines.

The rear is lifted via long add-a-leaf springs and heavy-duty extended shackles that level the stance and improve articulation. A transfer case drop bracket corrects the rear driveline angle, allowing use of the factory driveshaft. This kit is specifically configured for XJs with the Chrysler 8.25 rear axle, identifiable by a 3" inner diameter on the rear U-bolts.

All four corners are upgraded with Fox 2.0 Adventure Series shocks built specifically to complement Zone Offroad lift kits. These monotube shocks feature a 2" OD steel body, a 5/8" heat-treated hard chrome-plated shaft, and an internal floating piston that separates shock oil from the nitrogen gas chamber — eliminating oil aeration for consistent, fade-free performance on and off road.

Kit Includes:

• 4.5" front coil springs (Made in the USA)
• Front bump stop extensions
• Front extended sway bar links
• Brake line relocation brackets
• High-strength lower control arms (DOM tubing, greasable urethane ends)
• Transfer case drop bracket
• Rear long add-a-leafs and HD shackles
• Rear U-bolts with hardware

Note: This kit (J23F) is configured for the Chrysler 8.25 rear axle. To verify your axle, measure the inner diameter of the rear U-bolts — the Chrysler 8.25 uses a 3" I.D. U-bolt, while the Dana 35 requires a 2-3/4" I.D. U-bolt.