ATE ABS / Stability Control Hydraulic Unit
ATE ABS & Stability Control Hydraulic Units: The Original Source for ABS Technology
When it comes to ABS and stability control hydraulic units, few brands carry the engineering pedigree of ATE. As an aftermarket brand of Continental Corporation, ATE traces its ABS roots directly to the technology's origins — from the introduction of the first hydraulic brake system in 1926 to the development of the first antilock braking system prototype in 1967, the ATE brand has a rich history of innovation and experience in the design and production of advanced brake system technologies. That lineage matters enormously when you're replacing one of the most safety-critical components on a modern vehicle.
The ATE MK60: A Benchmark in ABS Hydraulic Control
The centerpiece of ATE's ABS / Stability Control Hydraulic Unit lineup is the ATE MK60 — a system found across a wide range of production vehicles. Continental has included the Hydraulic Control Unit (HCU), a major component of the ATE MK60 ABS controller, in its aftermarket portfolio. This was a landmark move for independent repair shops: for the first time, brand-independent workshops in the independent automotive aftermarket are able to access an original part for repairing antilock braking systems.
The ATE MK60 HCU works to increase directional stability, provide better maneuverability, and deliver a shorter braking distance, especially in wet conditions. The ATE MK60 provides precise braking by repeatedly lowering and raising the brake pressure to increase driving safety and reduce overall wear. Continental's range comprises products for models from BMW, Ford, Mazda, the Volkswagen Group, and Volvo.
A Smarter Repair Solution
One of ATE's most practical contributions to the aftermarket is how it rethought the repair process itself. In the past, there were two options: either the costly replacement of the complete ABS controller — consisting of the Electronic Control Unit (ECU) and the HCU — or the time-consuming task of opening the pressure sensor which is permanently connected to the ABS controller and asking a specialized company to overhaul it. ATE changed that equation entirely. Continental's ATE MK60 Hydraulic Control Unit can eliminate the need to replace the entire brake control (ECU) unit when only the HCU needs replacement.
The ATE MK60 HCU component package includes all necessary parts needed to complete installation, including motor, valve block, retaining device, two new screws, six stop plugs for the old HCU, and assembly instructions. The ATE repair set makes the replacement operation extremely safe and reliable for workshops: alongside the HCU, which is delivered already filled with brake fluid, the caps and screws and extensive installation instructions are also supplied together with the part.
OE Quality You Can Count On
Continental's OE braking systems expertise and leading-edge technology is built into every one of their aftermarket hydraulic brake parts. Every ATE component is made to meet and exceed OE manufacturer specifications and rigorously tested for endurance and reliability. For a safety-critical system like ABS — where a faulty pressure sensor can push the entire system into emergency mode — that level of quality assurance is not a luxury; it's a necessity.
An ABS today is equipped with up to 50 additional safety functions, such as the automatic release of the parking brake when starting off, hill start assist, or as a component of adaptive cruise-control systems. Choosing an ATE hydraulic unit means you're restoring all of those capabilities with the same engineering that went into the original system. For the full range of ATE braking products, visit the ATE brand page, or explore all available ABS / Stability Control Hydraulic Units.