Permatex Weatherstrip Adhesive
A door seal that peels away at the corner or a trunk gasket that lets in road noise is a small failure with outsized consequences: wind whistle, water leaks, and damp carpet. Permatex Weatherstrip Adhesive is a long-standing answer to that problem. It is a contact-type cement made to bond rubber weatherstripping to the metal of doors, trunks and body openings.
What Sets Permatex Weatherstrip Adhesive Apart
Permatex has supplied the automotive aftermarket since 1909, and its weatherstrip adhesive reflects that workshop experience. The product is an air-drying contact cement. It bonds quickly, yet it keeps enough tack to let you spread adhesive over a large area and join the surfaces in one pass. That working time matters when you are fitting a long door seal and need to line it up carefully. The finished bond is flexible and waterproof, and it resists both heat and cold, so it keeps its grip through summer sun and winter freeze-thaw cycles.
The adhesive is also formulated to resist gasoline, kerosene, antifreeze and most common solvents. Because of that, it works beyond door seals: it is commonly used for cut gaskets, auto and van carpeting, door and trunk moldings, vinyl tops, headliners and fabric-backed vinyl upholstery.
Black and Yellow Formulas
Permatex offers its weatherstrip adhesive in two colors and two tube sizes (2 oz and 5 oz). The black version blends in with black rubber seals, so any squeeze-out is far less noticeable and cleanup is easier. The yellow version is the classic choice for general bonding where color is not a concern. Both are sold in squeeze tubes that make it simple to lay down a thin, controlled bead.
Application Tips From the Manufacturer
- Clean both surfaces thoroughly. On new weatherstripping, scuff away any powdery mold release with an abrasive.
- Apply a thin, even film to both the seal and the body surface.
- Let the film dry until tacky, which takes roughly 3-4 minutes for the black formula, then press the surfaces together with firm, uniform pressure.
- Keep adhesive off exposed painted surfaces, and cap the tube tightly after use.
Contact cements reach full strength only after the solvent has fully released, so avoid trapping wet adhesive between two non-porous surfaces. Doing so slows drying and delays the bond reaching its maximum strength.
Choosing the Right Product
For restoration work, door seal replacement or trunk gasket repair, match the color to your seal and the tube size to the job. A 2 oz tube suits a single repair, while a 5 oz tube covers a full set of door seals. To see how other makers approach this job, browse the full Weatherstrip Adhesive category. To explore Permatex's wider lineup of sealants, gasket makers, threadlockers and repair products, visit the Permatex brand page.