King CR2501 Shock Bearing Retaining Snap Ring 1.00" Bearing x 1.75" O.D.

The King CR2501 is a bearing retaining snap ring (C-clip) designed to snap into King Shock rod ends to retain the inner bearing. This precision-engineered component is an essential replacement part for maintaining the integrity and performance of King shock absorbers in off-road racing and performance suspension applications.

Specifications:

• Bearing Size: 1.00 inch inner diameter
• Outer Diameter: 1.75 inches
• Requires 2 clips per rod end
• Genuine King Shocks replacement part

This snap ring is specifically designed for King shock rod ends with 1.00-inch spherical bearings. The snap ring installs into machined grooves on both sides of the spherical bearing to securely retain it within the rod end housing. Proper installation is critical to prevent bearing migration during shock operation, especially under high-load conditions in off-road racing, rock crawling, and other demanding applications.

When replacing spherical bearings in King shock rod ends, it is recommended to install new snap rings to ensure proper retention and prevent potential failures. Always ensure the snap ring is fully seated in the groove and can rotate freely before returning the shock to service.