CSS Engine Coolant Temperature Sensor O-Ring
A coolant temperature sensor is only as reliable as the seal that holds it in place. The CSS Engine Coolant Temperature Sensor O-Ring is a small, purpose-sized part that does one job: keeping coolant inside the system where the sensor threads into the radiator hose housing. For BMW owners tackling cooling system repairs, it is the kind of inexpensive component that is worth replacing every time the sensor is disturbed.
What the CSS O-Ring Is Built For
CSS offers this seal as an 8 x 14 mm O-ring in black EPDM rubber. EPDM is a common choice for cooling system seals because it handles hot coolant and glycol-based fluids well. The part is specified for the coolant temperature sensor, BMW part number 13-62-1-433-077, which is located in the radiator hose. That sensor is also used for auxiliary electric fan control, so a weeping seal here can affect more than a drip on the garage floor.
Wide BMW Fitment
This single O-ring covers a surprisingly broad range of BMW models. Listed applications include:
- 3 Series, including the 323i, 325i, 325xi, 328i, 330i and 330xi from the E46 era onward
- 5 Series models such as the 528i, 540i, 525i, 530i and 550i, plus the 550i GT
- 7 Series models including the 740i, 750iL and 760Li
- M models including the M3, M5 and M6
- SUVs and roadsters such as the X3, X5, X6 and Z4
Because one size fits this many chassis, it is a handy part to keep on the shelf for anyone who services more than one BMW. Always confirm your vehicle's sensor part number before ordering, since fitment depends on the sensor type used in the radiator hose.
When to Replace It
An O-ring compresses to form its seal and can harden or take a set over years of heat cycles. Reusing an old one is a common cause of slow coolant seepage after a repair. Replace it whenever you:
- Remove or replace the coolant temperature sensor or fan switch
- Replace the radiator or lower radiator hose
- Notice coolant residue or a sweet smell around the sensor
- Find a persistent low coolant level with no obvious source
One owner reviewing this part noted it is the exact O-ring needed to seal the temperature sensors on the radiator and that it must be replaced when changing the radiator, which matches standard shop practice.
Installation Tips
Clean the sensor bore and inspect the sensor for cracks or corrosion before fitting the new seal. A light film of clean coolant on the O-ring helps it seat without rolling or tearing. Seat the sensor and retain it as specified for your vehicle, then top off and bleed the cooling system and check for leaks at operating temperature.
Explore More
To learn more about the manufacturer, visit the CSS brand page. For other sealing options and shopping considerations, browse the full Engine Coolant Temperature Sensor O-Ring category.