Allstar Performance Roll Bar Padding
Allstar Performance Roll Bar Padding for Race Cars and Roll Cages
In a race car, a driver's helmet, shoulders, and knees are never far from the tubing of the roll cage. Allstar Performance, a Michigan-based supplier of racing and performance parts, builds its roll bar padding around that reality, with options ranging from simple, colorful foam sleeves to SFI-rated pads for sanctioned competition. This page focuses on that lineup. For the full range of products from the manufacturer, visit the Allstar Performance brand page, or browse the broader Roll Bar Padding category to compare options from other makers.
Offset Foam Padding for Everyday Racing
The core of Allstar's lineup is its 36-inch foam roll bar padding, sold in black, red, blue, orange, yellow, and other colors. Two design details set it apart:
- Offset inside diameter: the bore is not centered, which makes the padding easier to slide on and places a thicker layer of foam toward the driver, where contact is most likely.
- Closed-cell foam: the material does not absorb moisture, and it progressively absorbs shock by becoming denser as it compresses.
These pads are listed for bars of roughly 1-5/8 to 1-7/8 inches in diameter and come in manageable 3-foot sections that can be cut to length. Multi-packs are available for builders padding an entire cage. Color options also make it easy to match a car's livery or to flag specific areas of the cage. Note that these standard offset pads are not SFI-approved, so check your sanctioning body's rulebook before using them where a rated pad is required.
SFI 45.1 Padding for Sanctioned Competition
For classes that require certified padding, Allstar offers SFI 45.1 roll bar padding in black. The product descriptions highlight several practical features:
- Peel-and-stick backing for straightforward installation
- 180-degree coverage where space is not a concern
- Two size ranges: 1-1/8 to 1-1/2 inch tubing and 1-5/8 to 2 inch tubing
- 3-foot lengths in black only
Matching the pad to your tubing diameter is the key step, since a snug fit keeps the padding where it belongs during hard impacts or vibration.
Mini Padding for Tight Spots
Standard padding can be too bulky in cramped cockpits, around door bars, or near the driver's knees and shoulders. Allstar's SFI Mini Roll Bar Padding addresses this with a compact, C-shaped profile that protects a specific area without taking up much room. It fits 1-1/4 to 1-3/4 inch tubing, uses a peel-and-stick backing, and meets SFI 45.1.
Choosing the Right Allstar Pad
- Measure the outside diameter of your tubing before choosing a size.
- Confirm whether your track or series requires SFI 45.1 padding.
- Choose offset foam for broad coverage and easy slip-on installation, or SFI and mini pads where certification or limited space is the priority.
- Consider color for visibility, inspection, and appearance.
Pair your padding with other cockpit safety gear from Allstar Performance for a well-rounded driver protection setup.